Cleading of Cone Crusher

The Cleading of the cone crusher is prone to severe wear due to frequent strong impacts. This can lead to issues such as uneven product particle size, decreased production efficiency, and increased energy consumption, so the replacement of the stone crusher lining plate is crucial.

When selecting a conical broken lining plate, the following three factors are generally considered: output, power consumption, and the wear resistance of the lining plate. Generally, the selection is based on the following principles: maximum feed size, changes in particle size, distribution of feed particle size, hardness of the material, and wear resistance of the material.

The longer the lining, the higher the power consumption. Short lining board for hard materials, long lining board for soft materials: short lining board for fine materials, and long lining board for coarse materials. Generally speaking, the amount of material smaller than the closed edge discharge port cannot exceed 10%. If it exceeds 10%, the power consumption increases and the product particle size becomes flaky. The increase in moisture content of viscous materials will affect the throughput of the material, and the moisture content of the material generally does not exceed 5%. The standard cone crusher should reach 75%~80%, and the short end cone crusher should reach 80%~85%.

The Crushing Equipment used for the lining plate of Rock Crusher is high manganese steel. Because it has high toughness and good impact hardening properties.